GRBL Firmware Parameter und USB Treiber

GRBL Parameterübersicht Kosy-CNC

$0=10 Step pulse, microseconds
$1=0 Step idle delay, milliseconds
$2=0 Step port invert, mask
$3=0 Direction port invert, mask
$4=0 Step enable invert, boolean
$5=0 Limit pins invert, boolean
$6=0 Probe pin invert, boolean
$10=1 Status report, mask
$11=0.010 Junction deviation, mm
$12=0.002 Arc tolerance, mm
$13=0 Report inches, boolean
$20=0 Soft limits, boolean
$21=0 Hard limits, boolean
$22=1 Homing cycle, boolean
$23=3 Homing dir invert, mask
$24=80.000 Homing feed, mm/min
$25=1025.000 Homing seek, mm/min
$26=25 Homing debounce, milliseconds
$27=1.000 Homing pull-off, mm
$30=24000 Max spindle speed, RPM
$31=0 Min spindle speed, RPM
$32=0 Laser mode, boolean
$100=400.000 X steps/mm
$101=400.000 Y steps/mm
$102=400.000 Z steps/mm
$110=1800.000 X Max rate, mm/min
$111=1800.000 Y Max rate, mm/min
$112=1800.000 Z Max rate, mm/min
$120=120.000 X Acceleration, mm/sec^2
$121=120.000 Y Acceleration, mm/sec^2
$122=70.000 Z Acceleration, mm/sec^2
$130=305.000 X Max travel, mm
$131=505.000 Y Max travel, mm
$132=100.000 Z Max travel, mm

 

Version #1
Erstellt: 27 Februar 2025 00:09:48 von Mario Voigt
Zuletzt aktualisiert: 27 Februar 2025 00:11:17 von Mario Voigt